DC Electrifier Usage Instructions

TREATING CANCER  
Studies have proven that tumors can be reduced or eliminated by application of a few milliamperes of electric current per square inch across the tumors. It is still important though to strengthen your immune system to remove dead cancer cells and not allow a recurrence of cancer later. It is recommended that only good habits are maintained by the patient. These include avoiding: alcohol, nicotine (from tobacco smoke), sugar (except for what occurs naturally in food), excessive animal protein consumption, and tap water (because of the fluoride and chlorine). It is necessary to sleep 8 hours every night, drink bottled spring water, take colostrum pills to boost immunity, expose your skin to sunlight, get exercise every day (to increase your blood oxygen), and eat fresh fruits (especially purple grapes) and fresh organic vegetables.

ELECTRODE PREPARATION & PLACEMENT
The cloth electrodes (1.5" and 3.75" square) should be completely wet with tap water. Connect the red alligator clip to the exposed copper wire on the small electrode, and the black alligator clip to the wire of the large electrode. Place the electrodes on the skin with the non-metal side touching the skin.

For cancer treatment the electrodes should be placed on the skin so that the electrical current flowing between them is also going through the tumor. The small electrode should be the one that's closest to the tumor. 

If the skin above a tumor is raw and the current creates too much pain then place the electrodes on opposite sides of the sore. It's also important that the electrodes are kept pressed to the skin so that the electric current remains evenly distributed. Place some plastic from a shopping bag between the electrodes and your hands if you are using your hands to hold them in place. But since the treatment time for cancer is long it would be best to use a long elastic bandage to hold the electrodes in place.

DEVICE CONTROLS
For cancer treatment the automatic/manual switch should have its lever toward "auto" to automatically have a regulated 5mA of current flowing between the electrodes. If this is too painful then you can switch to "manual" control and adjust the amount of electric current down with the current adjust dial. But using current levels lower than 5mA requires a longer treatment time. If 5mA is not painful then you also have the option of using the manual switch setting to go as high as 8mA (by turning the control dial). If 5mA is too painful then you can use the manual setting to acheive less than 5mA current.

INDICATOR LIGHT
The indicator light comes on fully when 5mA of electrical current is flowing between the electrodes and through the patient. If it won't light up when the unit is new then it's possible that the patient is dehydrated. In this case drink much spring water. If it won't come on then maybe the batteries have low voltage and need to be replaced which can be done after removing the four bottom case screws. The battery snaps can be pulled off of the existing batteries so the new ones can be connected. Alkaline batteries last the longest. Rechargeable batteries can be used but they actually put out less than nine volts.

TREATMENT TIME
Apply 5mA current across the tumor for 4+1/2 hours every day for 10 - 20 days. You can break up the treatment time into segments throughout the day.


ELECTRIFYING BACTERIA

A main contributor to the cause of cancer (besides toxins and radiation) is bacteria. The most common source for bacteria in the body is dental infections. Dr. Dowling (www.breastcancercured.com) found that almost always cancer patients have dental infections. He has verified this over the last 30 years of cancer diagnosis. He does an infrared scan on his patients to see the inflamed areas of the body that point to where the bacterial infections are. Then he sends his patients to a good dentist to clean out the infection if it's in the mouth. Bacteria cause a suppression of the body's ability to fight cancer. A scientific study (click here) in 1989 has proved the bacteria- killing ability of electric current. You can use this unit to kill bacteria any where in the body. Just place the electrodes on the body so that the infected area is between the electrodes and the small electrode is closest to the infection. Set the switch to "manual", turn the dial to the 2 o'clock position, and keep it on for 20 minutes which is enough to kill the bacteria. 

TREATING WOUNDS

Wound treatment for the first treatment is basically the same as cancer treatment the first time in that the current needs to be 5mA and the location of the electrodes should be on both sides of the wound so that the current flows through the wound. Treatment time is around 23 minutes. The following 7 treatments need to be around .4mA which can be found by setting the auto/manual switch to "manual" and turning the dial sufficiently counter-clockwise so that the patient doesn't feel the electric current. These 7 treatments need to be for 3 hours each time and the electrodes switched every 30 minutes so that the polarity is reversed.