Microbe Electrifier usage


The idea behind these instructions is to give you a guideline for amount of usage to match your body's amount of resultant cleansing so that you don't try to do too much too soon and get sick from excess cleansing. The immune system & liver & kidneys will cleanse the blood of deactivated viruses/bacteria/yeast but only at a rate that is unique to you. Therefore you should start out slowly and every week increase usage time if you feel up to it. If you have a Magnetic Pulser then use it first and don't start using the Microbe Electrifier till you stop getting major cleansing reactions from the Pulser.

Microbe Electrifier usage

It normally takes people 6-8 weeks to complete microbe electrification treatment although circulation impaired people and people with CFIDS, AIDS, and other immune dysfunction diseases often have to progress (increment the usage time weekly) more slowly which prolongs the total treatment time.
Precautions: It's best to do blood electrification first thing in the morning and even better if before eating anything. In the morning is when the blood is the cleanest and there is the least possibility of problems from transfection. If you are taking drugs in the evening and there is a chance your kidneys haven't fully cleaned the blood from them overnight then it's best not to use the frequency of 4 hertz in the morning. You'll have to wait till the evening to use it. 4 hz can be used before ingesting anything that can put many chemicals (natural or synthetic) into the bloodstream. 10 hz causes very little transfection, and 40 hz causes almost no transfection but both are less powerful against microbes than 4 hz.
Protocol: Start by using the Microbe Electrifier for 15 minutes. If the next day you don't feel very toxic (with headaches, tiredness, achiness, etc) then increase your usage time by 5 minutes. But if you get excess cleansing reactions then lessen the treatment time to 5-10 minutes. To aid the body expel the trash from the bloodstream you can drink a lot of water or celery juice and take as a diuretic parsley tea, watermelon, or cucumber. Your cleansing reactions determine the pace you need. It's normal to be able to increase your usage time once a week (if you're not having excessive cleansing reactions). Don't go so fast that you overly sicken yourself with excess cleansing reactions. If you don't start out slow the first 2 weeks then you may overly lower your immune system (from white blood cell lysing) so that you could get sick from some infection. I know of 2 people who used theirs at 4hz for 1 hour daily the first week and wound up getting pneumonia. Haste makes waste. Do enough time so that you feel cleansing reactions but don't overdo it. If you have an almost non-functioning immune system and don't experience any cleansing reactions then take an herbal immune booster such as Beta Glucan from www.nsc24.com to increase your immunity.
If you've used the device for 2 months and you are still getting cleansing reactions from it then you should continue using it daily until you no longer get those reactions and then for one more week for 2-3 hours daily (1 in the morning and 1-2 at night). Make sure the Microbe Electrifier is used every day without skipping any. AIDS patients need to use it the same time every day (+/- 2hrs) because HIV has a 1.2 day life cycle. For viral infections, if you skip a day then you'll have to continue using it for at least 21 days from that skipped day because of the 21 day life cycle of most viruses. Don't skip a day! If you are taking potent drugs and/or herbs more than once a day or are generally toxic due to poorly functioning kidneys then use the 40 hz setting to avoid transfection effects.
Positive Thinking: It may be helpful if you encouraged yourself daily to resist the tendency to become skeptical and give up. Do this by thinking positive thoughts about the new life you'll have once you've regained your health. It will be definitely worth any trouble encountered. Life can be so sweet when vitality brightens every moment of your existence.

Microbe Electrifier Instructions

To test for proper operation and strength of batteries: Flip the power switch to the ON position and the frequency switch to 4 hz. Press the Test button down and look at the Test Light to see that it is alternating in color between red and green. (At 40 hz the light will be green on one side and red on the other). If the four 9 volt batteries need replacement the Test Light will not light at all. To replace the batteries just use a Phillips screwdriver to unscrew the cases bottom 4 screws, pull off the cover, and then pull off the snap clips from each battery so that they can be replaced with new alkaline ones. Reinstall the padding as it was so as to prevent the batteries from rattling when the box is jiggled.

Choosing electrode site: Both electrodes on the inside of one wrist is the easiest site for convenient usage, but it affects the least amount of blood. But for some people the wrist is the preferred electrode site because it will allow more electrical current than other arrangements. Using one electrode on one wrist and the second one on the other wrist is my favorite because plenty of blood is affected. The only worry for some people might be any disliking of the electrical current by the heart (although most of the current travels through the blood and not through the heart muscles). Using the electrodes on both ankles affects the most amount of blood, but will barely allow enough electrical current for some people (due to mineral deficiencies) and is hardest for initiating and maintaining correct electrode placement.

Locating electrode placement sites for one wrist: The locations on the two main arteries is on the inner side of either wrist about 1+1/2 inches below the wrist crease to the outside of the main tendons, between them and the bones. Over these arteries, starting about 1" from the crease, is where the electrodes should be placed. (Avoid placing electrodes directly over the thumb side tendon to prevent muscular twitching during use.) The placement site for the little finger side is actually more on the side of the wrist. (picture)

Locating electrode placement sites for both wrists: The locations are the inner side of the wrists about 1+1/2 inches below the wrist crease to the outside of the main tendon on the little finger side or thumb side. Each wrist should have one electrode held in place by one wrist band. (picture) This is the most preferred electrode placement.

Locating electrode placement sites for ankles: On the inner side of each foot locate the pulse of the unseen artery between the ankle and the heel. If you can't feel it then go for a brisk walk for ten minutes and then feel for it without elevating your foot. On top of these pulsating arteries are the sites. (picture)

Connecting Electrodes: Clean & dry the electrode sites. Soak each of the cloth electrodes thoroughly with tap water or saltwater. Squeeze the middle of the insulation of the Microbe Electrifier's alligator clips (at the end of its wires) so that you open the jaws and then let them bite onto the electrodes ends. (picture) Place the electrode over the artery. Then put the elastic band around it and the wrist. Don't pull it tight. Just enough stretch to keep it in place is good. If using electrodes on the ankles, then attach them there with 1" wide medical tape. Re-wet the cloth electrode after 1 hour of use. 

Making Saltwater: If your tap water isn't very electrically conductive then you can make some saltwater by putting a couple of shakes of salt from the saltshaker into a cup of purified water and stirring it. This is very electrically conductive but also very corrosive to the alligator clips.

Using the device: Connect the wet electrodes to you. Turn the current control dial fully counter-clockwise, set the unit to 4hz, and flip the switch to the ON position. Turn the current dial clockwise until the current light comes on fully. (Then switch the frequency switch to the frequency setting you want to use.) The current light will indicate when you are getting 130ua through your bloodstream. If it won't light at maximum dial position then one of three conditions exist; 1) Your body's salt & mineral level is very low, 2) Where you placed the electrodes is unsuitable, 3) You need to use saltwater on the electrodes instead of tap water.
If your body's salt level is low then start salting your food with sea salt (which doesn't cause high blood pressure). If the electrodes 'sting' or 'bite' then 1) the current dial setting is too high, 2) your skin is dirty, 3) you need to relocate the electrodes.

Comfort Suggestions: If the elastic strap is too tight it will leave ridges on the skin when taken off. You can also sew something soft onto the inside of the band (if a natural fiber then not where the electrodes will be because natural fibers will wick away the electrodes moisture). If your skin becomes irritated where the electrodes touch then maybe you're applying too much current or you should place the electrodes on the ankles instead of the wrists.

Pad Electrode Usage: You can use the provided pad electrodes (or anything else made of 100% cotton) for treating any injured or infected area of the body (ie: gastritis, hepatitis, stomach virus, infected wound, sore throat, etc) by letting the electricity affect the area of the body that is between the two pads. That is what is meant by "localized treatment". To use them, first put the 3" square cloth pad electrodes into tap water until fully wet, then lightly squeeze out the excess. Connect each alligator clip onto the edge of each pad so that one of the 'jaws' is sandwiched inside the pad. Repeat for the second pad and alligator clip. Place them on your body so that the infected area is between them. Hold them in place with elastic or with plastic if you are holding them with your hands. Then with the frequency switch set to 4hz, and the current control dial (left side) fully counter-clockwise, turn the unit on and move the current control dial clockwise until you feel an electrical tingle. Treat for at least 30 minutes a day. Click here to read more about electricity promoting healing.

Click here for instructions on treating hepatitis.